Fasten the section by twisting it up into a knot and securing it with a medium-sized butterfly clip.
Cut the hair. The order you will cut the sections will vary based on the style you are trying to achieve. Some require you to cut from the back up, while others may dictate you cut from the front to the back.
Secure the middle section by twisting it and attaching a butterfly clip.
This works best on longer hair. If your sections are larger than the diameter of your rollers, then your curls will look limp. For short hair that’s at least 2 inches (5. 1 cm) long, you can try using very small rollers. If your hair is too short for rollers, follow the same rolling instructions using a 1-inch barrel curling iron, instead.
The smaller your sections, the tighter your curls will be. Remember, your sections should never be larger than the diameter of your rollers.
Pull the section up and across your forehead. Hold a roller diagonally on top of the ends, and roll the strip away from your face all the way to your scalp. Secure the roller. Continue rolling the left section of hair, front to back, by separating roller-sized pieces of hair and rolling in the same direction as the first. Secure each roller right next to your scalp.
If you take your rollers out too early, you will have a slight wave rather than curls.
The thicker the hair, the more layers you’ll want to section. Those with very thick hair can divide hair into 4-6 layers. Extra sections are added in the same method described below.
When the bottom layer is finished, continue separating small sections of hair in the middle layer. Smooth hair with the flat iron from a . 5 inches (1. 3 cm) away from your scalp down the hair shaft. Lift hair from your scalp when straightening the top layer. After separating small sections of your top layer of hair, place the flat iron as close to your roots as possible. Press the iron firmly closed and draw it down the hair shaft outward from your head. For pin-straight, divide each layer into small sections. Glide the straightener only a few times over each section before moving along. [5] X Research source If your prefer smoother hair, divide it into larger sections. Then clamp the flat iron tightly and run it over each part slowly, ensuring the heat penetrates each section but with less direct contact.
