Try to get replacement parts that are the same size and look as close as possible to the rest of your fence. Home improvement stores may also sell fence parts and repair kits.
These screws may be underneath the caps on the posts. Gently lift them with a hammer and chisel if you can’t remove them by hand. Keep the screws in a safe spot, such as a closed container, so they can be reused later.
Not all fences have pickets or screws. Your fence’s panels may be held in place with brackets, which you can slide the panels out of.
If the panel is next to a post, it may be attached with side brackets. Carefully move the panel to the side and out of the brackets.
If your posts are held in the ground with concrete, they most likely will not need to be adjusted.
In most fences, the panels will fit right next to each other without leaving a gap.
If the screw holes do not line up, you can fill the existing panel holes with spray foam, then drill new holes 1 in (2. 5 cm) deep.
Store the screws in a safe location and keep the old rails in case you need to measure them.
If you have the old rail, you can also measure it for use as an estimate.
Avoid wearing loose clothing or jewelry when operating a saw.
For the best results, choose a saw blade labeled for vinyl cutting. Fence companies and home improvement stores may sell these blades.
If the rail doesn’t fit properly, check the length again. You may need to cut it a little shorter.
The size of screws you need differ from rail to rail. Screws are usually included with new rails, but you can try using the screws from the old rail.
If you have trouble installing a post, removing the rails and fence panels completely can give you more space.
To remove the concrete, dig out the dirt around it. You can refill the hole later.
The post needs to be even and straight or else the rails and panels will not fit correctly.
The other person should hold the post straight. If it doesn’t look right, adjust it quickly before the concrete solidifies.
