A marker or pencil Scissors Ribbon Glue (Hot glue gun or crafting glue)
The plate should be facing up, or the position you’d normally eat from. It helps to position everything before you begin gluing. The angle of the top feather should be aimed outward. The feathers that follow should gradually begin pointing down and in. The lowest feather should end around the 8 o’clock mark.
Again, the angle of the top feather should be aimed slightly outward. The feathers that follow should gradually begin pointing down and in.
Make all visible glue marks on the inside of the plate.
Scrap cardboard Pen or pencil Scissors Crafting glue Ribbon or shoelaces
Ultimately you will cover the edges of the cardboard with coffee filters. Don’t restart if you cut an extra line in the cardboard or make a minor mistake.
Two ribbons will secure the wings to your back. The third and fourth ribbons are used to secure the wings together. The third ribbon will connect the top holes of both wings and the final ribbon should connect the bottom holes of both wings. The last two ribbons will be considerably shorter than the arm straps. Tie the ribbons in place to make sure that the wings can be slipped over the wearer’s shoulders. Make sure the cardboard can be seen from the wearer’s front.
Arrange the folded filters onto the cardboard and play with the design until you find a good fit. Experiment by folding multiple coffee into one fold.
Spare white t-shirts Hot glue gun Ribbon Spare cardboard Scissors Craft glue
Allow the glue to dry and settle for about ten minutes before continuing. Make sure the frames are symmetrical before continuing.
If you’re experiencing difficulties attaching the initial wire, begin gluing the wire as you wrap it. The glue and wires will eventually be covered up. There should be roughly eight loops per each needle. This will make about sixteen loops for each wing.
Be sure that the four triangles you use for one wing match the four triangles for the other wing.
Eagle wings are good to base your design on. Look in particular at the eagle wings in the extended-folded position. Another design you can use is to look up angle wings online to see all the variations of angle wings. The cardboard pieces do not have to look perfect or even. They will ultimately be covered up!
You may need to cut up your t-shirt to create a fitted look.
Attach the wings near the top of the wings, close to the wearer’s shoulder blades. Repeat the exact process for the opposite wing. You can use a small strand of ribbon to connect the two ribbons together. This will secure the wings to your back and bring them look close together. [5] X Research source
