If you’re having difficulty bending the wire, try using a pair of pliers to get a better grip. If you have a vice, you can also grab one part of the hanger in the vice and pull the other side.
If you like, you can straighten out the hanger’s hook and bend it into a wide curve, then tape the end to a spot on the mic stand behind the mic. Bend the wire as needed to get the screen in exactly the right spot. Use a clamp to hold the filter to the mic stand. You can get small, cheap clamps from most hardware stores for just a few dollars. Tape the filter to a second mic stand and position this in front of the first. Keep in mind that some mics are designed to take in sound from the top, while others are designed to take in sound from the front. You want the filter directly in front of the recording surface of the mic.
Listen to the way your “P,” “B,” “S,” and “Ch” sounds come out on your recording. You shouldn’t hear any “clipping” with these sounds as long as your volume levels are configured correctly. By contrast, not using a pop filter can leave your recording riddled with distortion.
Embroidery hoops usually have a fairly simple latch on one side. Undo this latch and slip the fabric over the inner hoop so that it stretches beyond its edges on all sides. Seat the inner hoop back inside the outer hoop and close the latch, keeping the fabric tight. See our embroidery hoop article for more help.
Screen door mesh can be found at most large hardware stores. It’s cheap, but you may be forced to buy a roll of the material, rather than the small amount that you actually need. [3] X Research source
Sing or talk through the filter and into the mic as normal. With this method, the filter is only one layer thick, but this is OK. It should work just as well.
Stiffer plastic lids are best. Flexible, floppy lids are not ideal.
For the stiffest plastic lids, you may need to use a drill, awl, or saw to get started. Be very careful when using these tools. A heavy pair of work gloves and proper eye protection are musts.
You can also use embroidery material or screen door mesh like in the section above, but this is a little harder. You can use clamps, binder clips, or tape along the back of the rim to keep these materials reasonably tight.
