Create a mid-high or high bun or ponytail. Don’t make a low bun or low ponytail. This method works the best for elastic headbands, but it may also work for silk scarves as well.
If you can, use a non-flexible, texturizing hairspray. [3] X Research source No hairspray? Try dry shampoo, sea salt spray, or a bit of hair wax or pomade.
If you’re using a silk scarf, place the knot on top of your head for a more secure hold. You may not even need to use bobby pins! You could also tie the knot at the back of your head to mix up your look. [5] X Research source
You need 1 bobby pin on each side of your head. Choose a bobby pin that matches your hair color so it will blend into your hair. [8] X Research source Make sure that the wavy side of the bobby pin is facing down against your hair, and that the flat side is facing up.
You can skip this step if you feel that the headband is secure enough.
You can try this method on non-stretchy, ribbon headbands that are connected with a small bit of elastic. If the headband is made from lace, use hot glue instead!
Match the color of the puffy paint to the elastic or to the printed design. Puffy paint is sometimes called “puff paint” or “dimensional fabric paint. " If you can’t find puffy paint, use hot glue instead. This is a great option for non-stretchy, lace headbands.
Make sure that the ends of the squiggly lines on the front and back of the headband match up. Puffy paint can take several hours to dry, so be patient. As it dries, it will look a little darker and flatter. If you ’e using hot glue, you only need to wait a few minutes. Hot glue sets up very quickly.
Be careful not to stretch the elastic too much. If you pull too much on it, the puffy paint or hot glue may snap. It should stand up to pulling it over your head, however.
This method is not recommended for sheer or lace headbands because the Velcro will be visible. Use the puffy paint method, but with hot glue.
If you can get Velcro in multiple colors, match the color to the ribbon. If you can’t find something narrower, get Velcro that’s the same width instead. Avoid self-adhesive Velcro. The glue isn’t very strong and it will create a sticky, gummy mess—not a good combination for hair!
If your ribbon is crimped when it joins the elastic, subtract 1 inch (2. 5 cm) from your Velcro. This way, the Velcro won’t bunch up when you glue it in. Keep the scratchy, hook side of the Velcro. Set the soft, loop side for another project.
Try to align the ends as best as you can. If you cut the Velcro 1 inch (2. 5 cm) shorter, then start gluing it 1⁄2 inch (1. 3 cm) from the end of the ribbon. If you don’t have hot glue, use fabric glue instead. It will work just fine, but it will take longer to dry.
Hot glue dries almost instantly, so it should be ready by the time you finish gluing the Velcro down. Fabric glue will need about 15 to 20 minutes to dry, however.
